1.
Clean surface thoroughly with alcohol or acetone.
2. Tape the
graphic into position.
3. Measure and adjust location of the graphic.
4. When you have the graphic in the position you desire, tape
down the center of the graphic.
5. Lift one side of the graphic and
separate the application tape from the backing paper. Using
scissors, cut away that half of the backing paper.
6. Hold the application paper away from the surface, keeping it
slightly slack and squeegee outward from the center . Press firmly
using overlapping strokes.
7. Discard
center strip of masking tape and lift remaining side of graphic.
Remove the backing paper and squeegee outward from the center.
8. Squeegee the entire graphic again pressing hard.
9. Remove the application tape by pulling it back over itself.
10.
Eliminate any air bubble with a pin and more the air out with your
finger or squeegee.
